Researchers at KAUST, Fraunhofer ISE, and University of Freiburg developed a method using 1,3-diaminopropane dihydroiodide (PDAI) to treat the perovskite surface of perovskite silicon tandem solar cells. The treated solar cells achieved a conversion efficiency of 33.1% and an open-circuit voltage of 2.01 volts. The devices maintained performance at over 40°C for over 1500 hours along the Saudi coast. Why it matters: This innovation overcomes challenges in surface passivation of textured perovskite cells, paving the way for more efficient and stable solar energy solutions suitable for deployment in hot climates.
KAUST researchers contributed to an international collaboration demonstrating that an ionic salt molecule called CPMAC enhances perovskite solar cell performance by 0.6%. CPMAC improves the electronic properties and reduces defects in the electron transfer layer compared to C60. CPMAC solar cells also exhibited greater stability, with a one-third reduction in power conversion efficiency drop compared to C60 cells under heat and humidity. Why it matters: This advancement addresses a key limitation in perovskite solar cell stability, potentially leading to more efficient and durable renewable energy solutions.
KAUST researchers found that inserting a magnesium fluoride layer in perovskite–silicon tandem solar cells can stall charge recombination and enhance performance. The magnesium fluoride interlayer effectively promoted electron extraction from the perovskite active layer and reduced charge recombination at the interface. The resulting tandem solar cell achieved a stabilized power conversion efficiency of 29.1%. Why it matters: Improving the efficiency of solar cells is critical for expanding renewable energy capacity in Saudi Arabia and worldwide.
KAUST researchers studied quantum dot (QD) solar cells, finding that QD size significantly impacts electron injection efficiency. Using femtosecond broadband transient absorption spectroscopy, they examined charge transfer between QDs and phenyl-C61-butyric acid methyl ester (PCBM). They demonstrated that smaller QDs with a bandgap larger than 1 eV facilitate electron transfer to PCBM upon light absorption. Why it matters: This work provides insights into optimizing QD solar cell design by tuning electron injection through QD size, potentially leading to more efficient and low-cost photovoltaic technologies.
KAUST scientists developed a new perovskite solar cell design using thin perovskite layers at the top and bottom of the interface. The new design achieves a power conversion efficiency of 25.6%, comparable to silicon solar cells, with only a 5% efficiency loss after 1000 hours of high heat exposure. The key innovation is the use of a specific ligand that interacts effectively with the 3D perovskites for passivation, maintaining purity in the thin layers. Why it matters: This advancement enhances the stability and efficiency of perovskite solar cells, making them a more viable and cost-effective alternative to silicon, especially for countries like Saudi Arabia aiming to increase renewable energy reliance.